![]() You can download the Drivers by clicking here Note: The product is available in Multiple colors Will be shipped randomly. The connector on the opposite side of this device is a USB connector and is intended to be plugged into the computer. The header for this ST-Link v2 programmer contains connections for 5V, 3.3V, SWCLK, SWDIO, SWIM, Reset (RST/NRST) and GND. Use this device to send program code to the 32-bit STM32 ARM Cortex or 8-bit STM8 microcontrollers. ST-Link V2 Programmer For STM8 and STM32 is fully consistent with the official version, support for automatic upgrades, support the full range STM32 SWD (only 4pins including SWCLK, SWDIO, and power) and a full range STM8 SWIM (only 4pins including SWIM, Reset and power) download and debug. SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed.SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector.500MA internal resettable fuse, complete protection of your expensive computer motherboard!.Shell characters using laser engraving, never fade off! Permanent clarity!. ![]() 5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V.Interface definition directly marked on the shell, clear, convenient and practical!.PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable!.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |